Customers in the HCT smashbox wet powder orders ca-6923a inspection found that a lot of bad products, each color has a
There aluminum plate deformation, noodles broken, noodles on external foreign body, aluminum plate placed on non-formation
2. 제품 상태:
Currently customers have a special release of the shipment 。
3. the reasons for the investigation:
(1) the aluminum plate deformation may be for two reasons:
A. because when incoming too much packaging (a box containing three bags, a bag with1000 aluminum plate) ， Resulting in an aluminum plate placed at the bottom due to load is too large, may result in part of the aluminum plate deformation;
B. depacket between the aluminum plate from the outside box off package does not pay attention light-light, or piling up too high, IP
(2) the noodle breakage due to some reasons employees will be placed into the container, aluminum plate, due to work is not careful, Your fingers cover the noodles bumps, packaging, front-line staff had not found this problem;
(3) non-performing items to view, the speculation noodles on the possible reasons for a foreign body has the following two points:
A. noodle on the tiny fibers may be the container itself with, it could be dust in the air in the fall to noodle on the packaging;
B. noodles on a small black and bright crumbs may be the cover of the container lid and the lens cover on the edge of the debris debris falling on to the
(4) the aluminum plate placed on the reasons for non-formation analysis:
A. the production process for aluminum plate placed in the container when the aluminum plate and then glue the bottom point of the aluminum plate ii A container, so that aluminum plate and the container can fit tight, Due to press the aluminum plate with your fingers will be noodles are very likely to cause damage, So use of the aluminum plate production line into the container, covered with lid, It will drop the container on the stage in operation to ensure the aluminum plate and the container fitting formation 。
B. see defect found in the high side of the aluminum plate side of the low non-performing products singled out in the aluminum plate and found to Glue does not point in the middle but in the aluminum disc aluminum plate edges (as shown in photo), resulting in aluminum pans Alice onwards
(5) the reasons for the incoming brush bad, employees in the packaging when they did not find this undesirable phenomenon.
4. Improvement measures:
(1) a. proposal to change the aluminum plate supplier of packaging methods;
B. rooms right off staff advocacy, the product package should pay attention to de-light-light and do not pile up too high 。
(2) on the production line in advocacy, aluminum plate placed in the container should be carefully placed to avoid the finger sets of bumps And cover the lid, shall review the whole noodle appearance, if it bumps, it should be isolated as non-performing products treatment
(3) the next batch production and packaging lines for testing to finally identify the foreign body is what causes the improvement and then provider
4) staff in the aluminum plate at the bottom of the follow-up dispensing, should glue the middle point in the aluminum disc aluminum plattes
(5) follow-up brushes to enhance the appearance of test and packaging to be right before the appearance of brush-wide review.
Investigator/date approved by/date: